Step 1: Nail preparation
- Disinfect Hands
Start by disinfecting both your own hands and your client's hands to ensure hygiene during the treatment.
- Groom Cuticles
Use a cuticle pusher to gently push back the cuticles. If you have the proper knowledge, perform an E-manicure. Remove excess cuticles with cuticle nippers or scissors for a neat finish.
- File Nails into Shape
File the nails into the desired shape with a 180 grit file. Ensure even edges and a smooth shape.
- Dull the Nail Plate
Lightly file the nails with a 240 grit file to remove the natural shine from the nail surface. This ensures better adhesion. File carefully to avoid damaging the nail plate.
- Remove dust residues
Brush the nail clean with a dust brush with 70% alcohol to remove dust.
- Degrease and Clean
Clean the nail surface thoroughly with 100% pure acetone to degrease the nail plate.
Step 2: Apply Ultra Bond
- Apply Ultra Bond
Apply a thin layer of The Gel Expert Ultra Bonding to the nail plate. This ensures extra adhesion between the natural nail and BLISS™. Allow to air dry for 30 seconds.
Step 3: Apply BLISS™
- Apply a gliding layer
Apply a thin gliding layer to the prepared nail plate. Use the The Gel Expert Fine Liner 10 mm brush and guide BLISS™ along the cuticles and side walls. This helps spread the next drop.
- Apply a building layer
Apply a medium-sized drop to the nail. Spread the product evenly from sidewall to sidewall, gently pulling it away from the cuticle to 2/3 of the nail. Avoid product accumulation at the free edge. Again, use the Fine Liner brush 10 mm to guide BLISS™ neatly along the cuticles, sidewalls, and towards the free edge.
- Allow product to level
Turn the hand over for a few seconds so that the product flows beautifully. This creates a natural curve (apex) on the nail. Check if BLISS™ has the desired curve.
- Cure
Cure the product:
90 seconds under an LED lamp
180 seconds under a UV lamp
- Work nail by nail
Build and cure one nail at a time, alternating between hands. This prevents the product from running into the cuticles or to the sidewalls.
Step 4: Finishing the nail
- Remove the sticky layer
Use 70% alcohol and a nail wipe to remove the sticky layer.
- Refine the nail shape
File the nail with a 240 grit file to prevent tearing or breaking and to create a sharp shape.
- Buff the nail
Buff the nail into shape with a 100/180 grit buffer, paying extra attention to the product around the cuticle and at the free edge.
- Remove dust residues
Use a dust brush in combination with 70% alcohol to make the nail dust-free.
Step 5: Apply Top Coat
- Apply Top Coat
Apply a thin, even layer of the desired The Gel Expert Top Coat.
- Cure
Cure the product:
60 seconds under an LED lamp
120 seconds under a UV lamp
- Apply Cuticle Oil
Apply a small amount of cuticle oil to each cuticle. Avoid contact with the nail to prevent the top coat from dulling.
- Color Finish (optional)
Do you want to finish the nail with The Gel Expert Gel Polish? Then follow the steps of the gel polish manual.
